Saab 9-5

since 1997 of release

Repair and car operation



Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + Systems of ignition, preheat and engine management
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      General information
      The storage battery - the general information, recommendations about service
      Charge system - general information and security measures
      Removal and generator installation
      Replacement of the block of the rectifier of tension and generator brushes
      System of start of the engine - the general information and precautionary measures
      Removal and starter installation
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and generator installation

Details of assembly of the generator are shown on an illustration.

Generator assembly

1 — Stator
2 — the Rotor with contact rings
3 — the Built-in fans

4 — the Rectifier
5 — a tension Regulator

Disconnect a negative wire from the battery.

4-cylinder engines

 PERFORMANCE ORDER

  1. Remove a casing (3 on an illustration) over the inlet pipeline, Ý/m the valve (4) ventilations of a case and valves of constant pressure.
  1. Weaken a tension (5) belts of a drive of auxiliary units and remove it then turn out the top bolt of the generator (6).
  2. Mark and give a nut (7) right support of the engine.
  3. Give a nut of a back support of the engine.
  4. Remove a lobby of section of an exhaust pipe (see. Head of the Power supply system and production of the fulfilled gases) and a hose between the pallet of a case and an oil separator.
  1. Disconnect electroconducting from B contacts + and D + the generator and turn out the bottom bolt of the generator.
  1. Turn the generator down, between the steering mechanism and intermediate shaft, then insert a strut between a transmission and a stretcher and remove the generator
  2. Installation is made as it should be, the return to an order of dismantle of components.

Petrol V6 engine

 PERFORMANCE ORDER

  1. Weaken a tension of a belt of a drive of auxiliary units and remove it a natyazhitel.
  2. Remove the right forward wheel.
  3. Remove the bottom protective casing of a wheel arch.
  1. Turn out 6 bolts of a pulley (7 on an illustration), remove Д/В pressure of impellent oil (8) and the right power shaft (9).

To Zakuporta an opening under Д/В pressure of impellent oil.

  1. Disconnect from the generator electroconducting and a sleeve of air cooling.
  2. Give 2 bolts of fastening of the generator and remove it through the right wheel arch.
  3. Installation is made as it should be, the return to an order of dismantle of components.

Diesel engine

 PERFORMANCE ORDER

  1. Weaken a tension of a belt of a drive of auxiliary units and remove a belt from pulleys.
  1. Disconnect from the generator electroconducting, turn out bolts of its fastening and remove the generator.
  1. Installation is made as it should be, the return to an order of dismantle of components.