Saab 9-5

since 1997 of release

Repair and car operation



Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling and power shafts
   General information
   + Coupling
   - Power shafts
      Removal and installation of power shafts
      Dismantling, assembly and cleaning of hinges of power shafts
      Removal and installation of an intermediate shaft and its bearing
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


, samsung.



Power shafts

Removal and installation of power shafts

 PERFORMANCE ORDER

  1. To Poddomkratta the car also remove the corresponding wheel and the left lateral protective casing. On the diesel V6 models remove the bottom protective casing of the engine.
  2. Remove a cap of a stupichny nut and give it.
  3. At removal of the right power shaft give fixture of an arm of the sensor of an inclination of headlights (at the corresponding complete set) and take him aside.
  4. Turn out a bolt of fastening of a spherical support to a rotary fist and lower the suspension bracket lever, having fixed it in this situation by the wooden whetstone established between the lever and a rack of the stabilizer.
  5. Weaken a collar of a brake hose and fixture of electroconducting of ABS.
  6. Beat out the external CV JOINT from a nave by means of a hammer with soft the brisk. For simplification of removal of a shaft delay a suspension bracket rack.

Do not damage a shlitsa of a shaft.

  1. At removal of the left power shaft accurately hook the lever the internal CV JOINT and deduce it from transmission.

Thus oil will follow from transmission.

  1. For removal of the right power shaft beat out it from an intermediate shaft a hammer with soft the brisk.

The internal CV JOINT of the right power shaft on shlitsa has the lock ring established in a flute for fixing with intermediate shaft.

  1. Before installation of the left power shaft replace its epiploon (see. Head Manual box of gear shifting).
  2. Be convinced of integrity and correctness of installation of lock rings in their flutes, and also in purity шлицов an established shaft.
  3. Establish a shaft in a nave, having delayed a suspension bracket rack.
  4. Grease shlitsa of the internal end of a shaft with transmission oil and establish a shaft in transmission / an intermediate shaft to a zashchyolkivaniye of a lock ring.
  5. Further installation is made as it should be, the return to an order of dismantle of components. Use a new stupichny nut.