|
|
Saab 9-5since 1997 of releaseRepair and car operation |
|
|
Saab 9-5 + Saab 9-5 Cars + Governing bodies and operation receptions + Settings and routine maintenance of the car + Engine + Systems of cooling of the engine, heating, ventilation and air conditioning + the Power supply system and production of the fulfilled gases + Systems of electric equipment of the engine + Manual box of gear shifting + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering General information, recommendations and security measures + Forward suspension bracket + Back suspension bracket + Steering - Suspension bracket geometry Corners of installation of wheels of the car - the general information Check and adjustment of corners of installation of wheels + Body + Onboard electric equipment |
Suspension bracket geometry Corners of installation of wheels of the car - the general information Corners of installation of wheels considerably influence stability of the car, wear of tires and fuel consumption. Nominal rates of corners are specified in Specifications. The tilt angle of the plane of a wheel concerning a vertical is called as disorder. If wheels are inclined by the upper edges outside, disorder is called as positive. The size of disorder is measured in degrees. Correctness of adjustment of disorder defines size and the provision of a spot of contact of a protector with a paving and allows to compensate changes in geometry the suspension brackets occurring during commission of turns and at movement of the car on a rough paving. Disorder of forward wheels The data size to each other forward edges of wheels of the car (=B-A) is called as convergence (convergence). Such violation of parallelism of installation of wheels allows to minimize wear of a protector at the expense of prevention юза at commission of turns. Violation of adjustment of convergence conducts to acceleration of wear of protectors of tires at the expense of a proskalzyvaniye them on a paving. Convergence of forward wheels Vybegom is called a corner of a longitudinal inclination of an axis of turn of a wheel, i.e. a corner of a deviation of this axis from a vertical in the rim plane. If the axis of turn is inclined back, выбег is called as positive, and on the contrary. Выбег forward wheels The corner of a cross-section inclination of an axis of turn of a wheel - a corner of a deviation of this axis from a vertical if to look at a wheel in front of or behind the car. If the axis of turn is inclined inside, this corner is considered positive. Corner of a cross-section inclination of an axis of turn of a forward wheel The size of limiting angles of rotation of forward wheels of the car should be lowered at increase in the size of the last. Limiting angles of rotation of forward wheels |
|