Saab 9-5

since 1997 of release

Repair and car operation


Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   + System of cooling of the engine
   - Systems of heating, ventilation and air conditioning
      General information
      Removal and control unit installation by ventilation system with a heater and To/in, removal and installation of the broad valve
      Replacement of the valve of an otsechka of cooling liquid and it Ý/m the valve
      Removal and installation of the fan of a heater
      Removal and heat exchanger installation
      Removal, repair and To/in compressor installation
      Removal and installation of the sensor of temperature in salon
      Removal and installation of the step-by-step engine of a zaslonka of mixing of air and э / motor of a zaslonka of a mode of air circulation
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and control unit installation by ventilation system with a heater and To/in, removal and installation of the broad valve

 PERFORMANCE ORDER

  1. Empty heating system, having disconnected hoses from the heat exchanger. On models with To/in discharge К/В system.
  2. Remove the central section of the dashboard and forward seats (see. Head Body).
  3. Unbend a sexual covering and remove air lines under forward seats.
  4. Remove the dashboard (see. Head Body).
  1. Disconnect from a beam of the dashboard of a wire of grounding (6 on an illustration), cut cable couplers (7), give nuts and remove the average cable channel (8).
  1. Remove a knee emphasis.
  1. Turn out 3 bolts and remove the holder of the relay.
  1. Turn out 4 screws of fastening of a steering column and remove it in collecting (see. Head Suspension bracket and steering).
  1. Turn out 4 bolts (13 on an illustration) and remove an arm of pedals.
  1. Turn out on 2 screws on each party (14 on an illustration) and remove two basic brackets of the central part of a beam of the dashboard.
  2. Remove the stabilizer (15 on an illustration) on the central support and turn out 8 bolts of the central support (16).
  1. Turn out on 2 bolts of external support (17 on an illustration) and remove a beam (18) dashboards.
  1. On models from AT separate the socket of the AT control unit and put it aside (19 on an illustration).
  1. Separate 4 sockets of the block of ventilation and heating from the passenger (20 on an illustration).
  2. Lift the receiver, going from an interkuler to the throttle case.
  1. Remove the holder Ý/m the valve of the perepuskny valve of nadduvayemy air. For this purpose at first uncover, then remove from the holder the socket and separate it then remove the holder from a partition of an impellent compartment and put aside.
  1. Disconnect two hoses from the heat exchanger (23 on an illustration) and tubes (24) To/in from the broad valve, previously having turned out the central bolt.
  1. Turn out 2 bolts and remove the broad valve.
  1. Disconnect drain hoses on both parties of the block of ventilation and heating.
  1. Turn out from an impellent compartment three screws of fastening of the block of ventilation and heating to a partition.
  1. Raise a back part of the block and deduce it from a support.
  2. Installation is made upside-down. Use new sealing rings.