Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
+ System of cooling of the engine
- Systems of heating, ventilation and air conditioning
General information
Removal and control unit installation by ventilation system with a heater and To/in, removal and installation of the broad valve
Replacement of the valve of an otsechka of cooling liquid and it Ý/m the valve
Removal and installation of the fan of a heater
Removal and heat exchanger installation
Removal, repair and To/in compressor installation
Removal and installation of the sensor of temperature in salon
Removal and installation of the step-by-step engine of a zaslonka of mixing of air and э / motor of a zaslonka of a mode of air circulation
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of the valve of an otsechka of cooling liquid and it Ý/m the valve
|
|
These valves are riveted with each other. |
|
|
- Uncover a broad tank and dump pressure in system. Substitute under the car capacity for collecting OZh.
|
|
- Press water hoses (3 on an illustration) and disconnect from valves vacuum hoses (4).
|
|
|
Check at the same time a condition of hoses. |
- Separate the socket (5 on an illustration) Ý/m the valve and cut the cable coupler (6) holding together Ý/m the valve and electroconducting.
|
|
- Remove collars (7 on an illustration) fastenings of hoses to Ý/m to the valve and drill rivets (9).
|
- Replace the valve of an otsechka or it Ý/m the valve.
- Installation is made upside-down. Instead of rivets use boltovy connection.
|
|
|
|