Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling and power shafts
General information
- Coupling
Removal, check and installation of assembly of coupling
Removal and installation of a pedal of coupling and its arm
Removal and installation of the main and executive cylinders
Pumping of coupling and its executive cylinder
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the main and executive cylinders
Main cylinder
|
|
- Remove the lower left part of the dashboard (under a steering wheel).
- Remove from a coupling pedal a spring, then remove a clamp and take out a pin.
- Remove the storage battery. On the diesel V6 models remove the top thermofilter of a turbokompressor.
- Clean aside the assembly block of the relay and safety locks in an impellent compartment.
- Pump out brake liquid from the pumping union.
|
|
- Disconnect submitting hose (9) from the tank of brake liquid and separate the ABS block socket (10). Take the socket aside.
|
- Clear area round connections of brake tubes (13), disconnect them and закупорьте open openings.
- Remove the ABS block.
|
|
- Give fixture and remove ABS arm.
|
|
|
- Remove a bracket (16) fastenings of a submitting tube to the main cylinder, disconnect a tube (17) and turn out nuts (18) fastenings of the main cylinder (19).
|
- Remove the old main cylinder and rearrange a hose (20) on the new cylinder.
- Installation is made upside-down. After installation pump over coupling (see. Section Pumping of coupling and its executive cylinder).
|
|
Executive cylinder
|
|