- Establish the car on an equal platform, lift a pillow of a back seat and unbend a sexual covering.
|
|
- Uncover (2 on an illustration) the sensor of a stock of fuel, separate its socket (3) and cut a cable coupler.
|
- Disconnect two contacts from the brown socket (4 on an illustration).
- Accurately disconnect from a fuel tank control valves and fuel lines, previously having marked their situation not to mix at installation.
- Turn out a screw ring.
- Raise fuel capacity assembled with the sensor of a stock of fuel so that its top part towered approximately on 5 cm over a fuel tank then turn assembly on an hour arrow on a corner approximately on the 80th hail. also remove it from a tank.
|
|
Prepare for an effluence of a small amount of fuel. |
- Clear interfaced surfaces and establish in a groove of a fuel tank a new sealing ring.
- Further installation is made upside-down. If necessary replace sealing rings of connections of fuel hoses with the pump.
|
|