Saab 9-5

since 1997 of release

Repair and car operation


Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- Power supply system and production of the fulfilled gases
   General information and security measures
   Sbrasyvaniye of pressure in fuel system
   + Power supply system of petrol engines
   - Power supply system of the diesel V6 engine
      General information
      Removal and installation of a sleeve of an air inlet, case of the air filter and MAF sensor
      Removal and installation of the inlet pipeline
      Replacement of the sensor of provision of a pedal of gas
      Replacement of sensors of a turbo-supercharging and sensor of temperature of fuel
      Replacement of the valve of management with pressure of pressurization
      Removal and turbokompressor installation
      Removal and installation of an interkuler
      Removal and installation of a fuel tank
      Replacement of the fuel filter
      Removal and installation of the fuel distributive highway
      Removal and installation of the sensor of a stock of fuel
      Removal and TNVD installation and replacement of its epiploon
      Removal and installation of nozzles
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the inlet pipeline

 PERFORMANCE ORDER

  1. Disconnect submitting tube from a turbokompressor and the MAF sensor then remove the top cover of the engine.
  1. Separate sockets, remove the forward cable channel and shift aside engine electroconducting (3 on an illustration).
  1. Remove the top section of the inlet pipeline and a turbokompressor arm (4 on an illustration).
  1. Remove fuel tubes and the fuel distributive highway.
  1. Remove the EGR valve and a water hose. Disconnect and put aside EGR tube with a water shirt, and also a tube to a turbokompressor.
  1. Lift the receiver case ventilation (7 on an illustration) and the bottom section of the inlet pipeline (8) from both blocks of cylinders.
  1. Installation is made upside-down. Previously clear interfaced surfaces and establish new laying. Besides, use new consolidations of understanding connections, and also new submitting fuel tubes.