Saab 9-5

since 1997 of release

Repair and car operation



Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- Power supply system and production of the fulfilled gases
   General information and security measures
   Sbrasyvaniye of pressure in fuel system
   + Power supply system of petrol engines
   - Power supply system of the diesel V6 engine
      General information
      Removal and installation of a sleeve of an air inlet, case of the air filter and MAF sensor
      Removal and installation of the inlet pipeline
      Replacement of the sensor of provision of a pedal of gas
      Replacement of sensors of a turbo-supercharging and sensor of temperature of fuel
      Replacement of the valve of management with pressure of pressurization
      Removal and turbokompressor installation
      Removal and installation of an interkuler
      Removal and installation of a fuel tank
      Replacement of the fuel filter
      Removal and installation of the fuel distributive highway
      Removal and installation of the sensor of a stock of fuel
      Removal and TNVD installation and replacement of its epiploon
      Removal and installation of nozzles
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and TNVD installation and replacement of its epiploon

 PERFORMANCE ORDER

  1. To Poddomkratta the car also remove the bottom protective casing of an impellent compartment.
  2. Weaken a tension of a belt of a drive of auxiliary units and remove it a natyazhitel (see. Head Engine).
  3. Give a forward bolt of a forward support of the power unit.
  4. Lower the car and remove submitting tube from a turbokompressor (1 and 2 on an illustration). Remove the top cover of the engine.
  1. Give quick disconnect connections of fuel lines (7 on an illustration), unload support of the engine and remove the right support (8) together with an arm and a pillow. Slightly raise the engine to take bolts.
  1. Remove a belt of a drive of auxiliary units and its intermediate pulley (see. Head Engine).
  2. Remove top section of the inlet pipeline and the fuel distributive highway with tubes (see. Section Removal and installation of the inlet pipeline).
  3. Remove TNVD cogwheel, a pulley of a cranked shaft and an intermediate pulley (see. Head Engine).
  1. Uncover TNVD drive.
  1. In need of only replacement of an epiploon of TNVD make it at this stage.
  1. Remove the EGR valve and a water hose.
  1. Remove the bottom section of the inlet pipeline from both heads of cylinders (see. Section Removal and installation of the inlet pipeline).
  1. To Zakuporta an opening in a head of cylinders also remove a hose of ventilation of a case. For simplification of installation and prevention of possible damages separate the TNVD socket (26 on an illustration).
  1. Disconnect fuel lines (27) from TNVD.
  1. Turn out blocking bolt from a gear wheel of TNVD and screw in it two bolts М6.
  1. Tighten bolts consistently that the external part of a gear wheel weakened.
  2. Screw bolts in openings in an internal part of a gear wheel of TNVD and remove it.
  1. Remove TNVD, paying attention to an arrangement of bolts of different length.
  1. Installation is made upside-down. Use new laying of TNVD and new consolidations of understanding connections.