Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
General information, recommendations and security measures
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of a nave of a back wheel
Removal, dismantling, assembly and installation of a rack of a suspension bracket
Removal and installation of a stretcher and cross-section drafts
Removal and installation of the stabilizer of cross-section stability
Removal and installation of the longitudinal lever
+ Steering
+ suspension bracket Geometry
+ Body
+ Onboard electric equipment
|
Removal, dismantling, assembly and installation of a rack of a suspension bracket
|
|
- To Poddomkratta the car also remove the corresponding wheel.
|
|
- Turn out the bottom bolts of an arm of a rack and slightly give the top bolts.
|
|
|
- Turn out the bottom bolt of fastening of a rack (3) and remove it.
|
|
|
- Holding the shock-absorber from a provorachivaniye, slightly give a nut (5) fastenings of a spring.
|
|
|
The reuse of this nut is not admissible. |
- Squeeze out down an arm (6) springs to unload the shock-absorber and finally give a nut, a washer and the rubber plug. If necessary use the adaptation for spring compression.
- Remove the shock-absorber, a spring and a spring pro-rate.
- Assembly and installation are made upside-down. Tighten fixture with demanded efforts.
|
|
|
|