Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
General information, recommendations and security measures
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of a nave of a back wheel
Removal, dismantling, assembly and installation of a rack of a suspension bracket
Removal and installation of a stretcher and cross-section drafts
Removal and installation of the stabilizer of cross-section stability
Removal and installation of the longitudinal lever
+ Steering
+ suspension bracket Geometry
+ Body
+ Onboard electric equipment
|
Removal and installation of a stretcher and cross-section drafts
Removal
|
|
At removal of one of cross-section drafts of a suspension bracket described below operation it is enough to make only on one party of the car. At removal of the top draft it is required to remove the bottom draft. |
|
|
- To Poddomkratta the car also remove back wheels.
- Unhook an exhaust pipe from central and back rubber подвесов and suspend it so that not too strongly to load lobbies подвесы and flexible section.
|
|
- Turn out fastening bolts at first bottom (3), and then the top (4) cross-section bent for to the longitudinal lever from both parties of the car.
|
- From both parties of the car turn out bolts (5) fastenings of the stabilizer to cross-section draft.
|
|
Installation
|
|
- Fix on a stretcher the stabilizer and cross-section drafts. Fixture of drafts yet do not tighten finally.
|
|
Use new bolts of fastening of bent for to a stretcher. |
- Establish into place stretcher assembly with drafts and the stabilizer. Stretcher fixture yet do not tighten finally.
- Fix on longitudinal levers the stabilizer, and then the top and bottom drafts.
- Tighten bolts of fastening of a stretcher.
- Establish an exhaust pipe on rubber подвесах, establish wheels and lower the car on the earth.
- Tighten bolts of fastening of bent for to a stretcher.
|
|
At a tightening of bolts the car should stand on the earth on all wheels. |
- Check convergence of back wheels and if necessary adjust it (see. Suspension bracket geometry).
|
|
|
|