Saab 9-5

since 1997 of release

Repair and car operation


Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information, recommendations and security measures
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of a nave of a back wheel
      Removal, dismantling, assembly and installation of a rack of a suspension bracket
      Removal and installation of a stretcher and cross-section drafts
      Removal and installation of the stabilizer of cross-section stability
      Removal and installation of the longitudinal lever
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment


Removal and installation of the longitudinal lever

 PERFORMANCE ORDER

  1. To Poddomkratta the car also remove wheels.
  2. Squeeze out the piston of the brake cylinder, turn out bolts of fastening of a brake support and suspend it on a body (see. Section Removal and installation of brake supports).
  1. Remove the air deflector (4), turn out a bolt (5) fastenings of an arm of a cable of a drive of the parking brake, separate the socket of the wheel sensor (6) and liberate its electroconducting from the holder.
  1. Turn out nuts of the holder of electroconducting of the wheel sensor and a brake tube (8).
  1. Turn out the bottom bolt (9) fastenings of a rack of a suspension bracket and a bolt (10) fastenings of the bottom cross-section bent for to a rotary fist.
  1. Unhook a returnable spring of a cable of a drive of the parking brake and remove a cable (11).
  2. Turn out bolts (12 and 13) fastenings of the stabilizer and the top bent for to the longitudinal lever.
  1. Turn out bolts of fastening of the longitudinal lever to a body and lower the lever together with a nave and a brake disk.
  1. Turn out from the longitudinal lever a nave with a brake disk.
  1. Establish on the longitudinal lever the special adaptation (16), turn out a bolt (17) and remove from the lever the special adaptation and an arm.
  1. Installation is made upside-down. Use new bolts of fastening of a nave.