Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
- Engine
General information and preparatory operations
Check of kompressionny pressure
Engine check by means of the vacuum gage
+ Repair of 4-cylinder petrol engines
- Repair of 6-cylinder petrol engines
Reduction of the piston of the first cylinder in situation VMT and replacement of a belt of a drive of auxiliary units and its natyazhitel
Removal and installation of the inlet pipeline, belt of a drive of GRM and heads of cylinders
Dismantling and assembly of the klapanny mechanism
Replacement of epiploons of a cranked shaft
Removal and installation of the pallet of a case and maslootrazhatelny plate
Replacement of the oil pump and its valves
Replacement of the perepuskny valve of system of greasing of the engine
Removal and installation of the power unit
+ Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the pallet of a case and maslootrazhatelny plate
|
|
- Separate the electroconducting socket a lambda probe (1 on an illustration) and cut a cable coupler holding it. Remember a route of laying of electroconducting and take away it down. Give two top nuts of fastening of forward section of an exhaust pipe to a turbokompressor.
|
|
Socket (1) lambda probe and section of a protective casing (3).
|
- To Poddomkratta the car also establish it on props. Remove the bottom back section of a protective casing of the engine (3 on an illustration).
- Remove forward section of an exhaust pipe.
|
|
- Lower impellent oil (5 on an illustration), give bolts of fastening of the pallet of a case (6) and remove it.
|
- Remove a maslozabornik (7 on an illustration) with a sealing ring and a maslootrazhatelny plate (8).
- Installation is made upside-down. Previously clear interfaced surfaces. If the sealing ring of a maslozabornik is damaged, use the new. On a carving of bolts of fastening of a maslootrazhatelny plate, a maslozabornik and the pallet of a case put fixing hermetic. Tighten fixture with demanded efforts.
|
|
|
|