Saab 9-5

since 1997 of release

Repair and car operation

Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   General information and security measures
   Pumping of brake system and replacement of brake liquid
   Replacement of brake shoes
   Removal and installation of brake disks
   Removal and installation of brake supports
   Removal and installation of a pedal of a brake
   Removal and installation of the vacuum pump
   Removal and installation of the tank of brake liquid and GTTs
   Removal and installation of brake lines
   Removal and installation of components of the parking brake and its drive
   Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of brake supports


  1. Removal of forward supports, and also back floating supports from an anchor bracket is described in the Section Replacement of brake shoes. For final removal of a support it is necessary to disconnect a brake hose from it. After a hose detachment закупорьте its open end and an opening in a support.
Fastening (6) forward supports to an anchor bracket and connection (5) hoses with a support.
  1. Before disconnecting a brake hose from a back floating support, the hose should be disconnected from a brake tube. For this purpose remove a clamp, disconnect a hose from a tube and закупорьте a tube.
  1. For removal of a motionless back support remove brake shoes (see. The section Replacement of brake shoes), disconnect from a support a brake tube and turn out its fixing bolts (see an illustration).

The open end of a tube and opening in a support закупорьте that dirt did not get to them.

  1. At connection of a brake hose to a support (lobbies and back floating supports) watch that the hose was not overwound. After installation of a support pump over brake system.