Saab 9-5

since 1997 of release

Repair and car operation

Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
- Manual box of gear shifting
   Transmission identification
   General information
   Removal and installation of a casing of the lever of gear shifting
   Adjustment, removal and installation of a drive of gear shifting and ignition lock
   Replacement of the handle of the lever of gear shifting
   Removal and RKPP installation of 4-cylinder engines
   Removal and RKPP installation of diesel V6 engines
   Removal and Д/В installation of lamps of a backing
   Replacement of epiploons of power shafts
   Design and major maintenance of a transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a casing of the lever of gear shifting



  1. Remove the central console (see. Head Body).
  1. Include the 4th transfer and fix RKPP in this situation by means of the special adaptation (2) or a screw-driver in diameter of 4 mm.

The lock core should not fail in an opening. Give a hinge (3) bolt.

  1. Turn out bolts (4) fastenings of a casing of the lever of gear shifting and separate the socket (2) electroconductings of the lock of ignition.
  1. Remove a casing.



  1. Establish a casing into place, join the socket of electroconducting of the lock of ignition and fill electroconducting in a casing.
  2. Establish an air line of system of ventilation and tighten bolts of fastening of a casing, having paid attention to its 2 directing pins (arrow).
  3. Include the 4th transfer and insert a clamp (5) into an opening in a casing.
  4. Tighten a hinge bolt, take from RKPP and a casing holding adaptations and close an opening on RKPP a plastic stopper.
  5. Make sure of serviceability of inclusion of each transfer, and also that the ignition key can be taken from the lock by the chosen transfer of a backing.
  6. Establish the central console.