- Remove the gear shifting lever (see. The section Adjustment, removal and installation of a drive of gear shifting and the ignition lock) also clamp it in a vice.
- Wind with a tape a neck under the handle, establish on a tape a rozhkovy key on 32 mm and slightly strike on it from below with a hammer to bring down the handle with the holder from the lever.
|
|
- Remove a tape, and then remove the handle from the holder, having pressed a thin screw-driver clamps on the holder.
|
|
|
Pay attention to that under the handle the spring is established. |
- Installation is made upside-down.
|
|