Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
- Manual box of gear shifting
Transmission identification
General information
Removal and installation of a casing of the lever of gear shifting
Adjustment, removal and installation of a drive of gear shifting and ignition lock
Replacement of the handle of the lever of gear shifting
Removal and RKPP installation of 4-cylinder engines
Removal and RKPP installation of diesel V6 engines
Removal and Д/В installation of lamps of a backing
Replacement of epiploons of power shafts
Design and major maintenance of a transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Adjustment, removal and installation of a drive of gear shifting and ignition lock
Components of a drive of gear shifting
Removal
|
|
- Remove a casing of the lever of gear shifting (see. Section Removal and installation of a casing of the lever of gear shifting).
- Remove the holder (2) lock plates (4) and a spring holding it (3).
- By means of a screw-driver release a clamp (4) and extend a lock plate together with its plastic arm. Remove the limiter of a deviation (5). If necessary remove the ignition lock, having turned out screws of its fastening.
- Establish the gear shifting lever in the provision of transfer of a backing and turn out a bolt of its fastening to a gear shifting rod. If necessary replace lever plugs.
- Remove the lever of gear shifting and a holder, having accurately compressed a screw-driver three clamps on a holder.
|
|
Installation
|
|
- Establish a holder and the lever in a casing, watching that the sealing ring was between a holder and a casing.
- Fix the lever on a rod and establish the deviation limiter.
- Establish a lock plate and make sure that its 2 bearings are on a place.
- Latch clamps of a lock plate, establish its arm and a spring.
|
|
- Adjust the provision of a lock spring by means of the screw on her holder who should be up to standard with a ledge on a casing.
|
|
|
At adjustment the limiter of an inclination should not adjoin to a lock plate. |
- Establish a casing of the lever of gear shifting.
|
|
Adjustment
|
|
- Check serviceability of inclusion of all transfers.
- If necessary adjust the mechanism of a drive of gear shifting.
|
|
|
|