Saab 9-5

since 1997 of release

Repair and car operation



Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
- Automatic transmission
   General information
   Search of malfunctions - the general information
   Removal and installation of assembly of the lever of the selector of AT modes and its casing
   Removal, installation and adjustment of a cable of the selector of AT modes
   Removal and installation of the lever of the selector of AT modes and dismantling of its casing
   Removal and installation Ý/m AT valves, their case and its cover
   Removal and installation of sensors of speed
   Removal and installation of the AT hydraulic lines
   Removal and TCM installation
   Replacement and adjustment of the sensor of position of the selector of AT modes
   Removal and AT installation
   Replacement of epiploons of power shafts
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Replacement and adjustment of the sensor of position of the selector of AT modes

Replacement

 PERFORMANCE ORDER

  1. Remove the storage battery together with its pallet.
  1. Clear area round a joint of a jellied tube of ATF with AT and lift the receiver (4).
  1. Establish the lever in situation "L", give a nut (5) and remove the lever (6).
  2. Turn out bolts (7) fastenings of the sensor of position of the selector of AT modes, разконтрите and give a nut (8) sensor fastenings.
  3. Separate the socket of the sensor and remove it from a shaft.
  4. Installation is made upside-down.

At first tighten bolts, and then a sensor nut.

Adjustment

 PERFORMANCE ORDER

  1. For adjustment the special adaptation is required.
  2. Establish AT in the mode "N", give bolts of fastening of the sensor and place on it the special adaptation.
  1. Move the sensor to situation in which the label on it would coincide with a cut on the adaptation.