Saab 9-5

since 1997 of release

Repair and car operation


Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
- Automatic transmission
   General information
   Search of malfunctions - the general information
   Removal and installation of assembly of the lever of the selector of AT modes and its casing
   Removal, installation and adjustment of a cable of the selector of AT modes
   Removal and installation of the lever of the selector of AT modes and dismantling of its casing
   Removal and installation Ý/m AT valves, their case and its cover
   Removal and installation of sensors of speed
   Removal and installation of the AT hydraulic lines
   Removal and TCM installation
   Replacement and adjustment of the sensor of position of the selector of AT modes
   Removal and AT installation
   Replacement of epiploons of power shafts
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal, installation and adjustment of a cable of the selector of AT modes

Removal and installation

 PERFORMANCE ORDER

  1. Remove the storage battery together with the pallet.
  1. Establish AT in situation "1" and remove an arm (2) selectors about AT, a clip (3) from a bracket of a cable and a cable (4) from a bracket.
  1. The subsequent removal of a cable is carried out during removal of assembly of the lever of the selector with its casing (see. Section Removal and installation of assembly of the lever of the selector of AT modes and its casing).
  2. Extend a cable and rubber consolidation in car salon.
  3. Installation is made upside-down. For simplification of installation of rubber consolidation grease it with vaseline. In conclusion of installation adjust a selector cable.

Check and adjustment

 PERFORMANCE ORDER

  1. Adjustment of a cable of the selector of AT modes is required, if a course of the lever of the selector in provisions "D" and "N" different.
  1. Establish the selector lever in the situation "P" and lift an adjusting clamp.
  1. Move the lever on AT to the situation "P" and drive the car before inclusion of blocking of the lever of the selector in the situation "P".
  2. Pull the lever on AT back to choose люфт and, holding the lever in this situation, press an adjustment clamp.
  3. Make sure that a course of the lever of the selector identical in provisions "D" and "N".