Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
- Brake system
General information and security measures
Pumping of brake system and replacement of brake liquid
Replacement of brake shoes
Removal and installation of brake disks
Removal and installation of brake supports
Removal and installation of a pedal of a brake
Removal and installation of the vacuum pump
Removal and installation of the tank of brake liquid and GTTs
Removal and installation of brake lines
Removal and installation of components of the parking brake and its drive
Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of components of the parking brake and its drive
Lever of a drive of the parking brake
|
|
- To Poddomkratta the car, from each party remove a returnable spring and unhook cables of the parking brake from its adjustable levers. Lower the car on the earth.
- Remove the central console and a casing from the lever of the parking brake (see. Head Body).
|
|
- Separate the socket of the sensor of the cocked parking brake (5) and remove a collar (6) electroconductings.
|
- Give 4 nuts of fastening of the lever of the parking brake (7), lift it and accurately extend up in salon equalizer assembly.
- Turn a tip of a cable of the parking brake on a corner the 90th hail. also separate it from the equalizer (9).
- Installation is made upside-down. After installation adjust the parking brake (see. Section Check of brake system).
|
|
Cables of the parking brake
|
|
- Release the parking brake and поддомкратьте the car.
- Separate forward section of an exhaust pipe from back section (see. Head of the Power supply system and production of the fulfilled gases).
|
|
- Remove left подвес (4) exhaust pipes, turn out two back fixing nuts (5) on the left side of the thermofilter (6) and unbend it to provide access to the equalizer.
|
|
|
- From each party of the car remove a returnable spring and unhook cables of the parking brake from its adjustable levers (7). Disconnect a cable from the equalizer, having turned its tip on a corner the 90th hail. (8).
|
- Extend a cable from the forward holder.
|
|
- To Poddomkratta a fuel tank, weaken collars of its fastening and remove cables.
|
- Installation is made upside-down. Stack cables on their original route. After installation adjust the parking brake (see. Section Check of brake system).
|
|
Boots of the parking brake
|
|
- Remove corresponding a back brake disk (see. The section of the Power supply system and production of the fulfilled gases).
- From each party of the car remove a returnable spring and unhook cables of the parking brake from its adjustable levers (7).
|
|
- Remove internal returnable springs and holding pins (4).
|
- Remove boots and the adjusting block (5).
- Examine adjustable levers (6) and the adjusting block on existence of damages and wear and if necessary replace them.
- Installation is made upside-down. After installation adjust the parking brake (see. Section Check of brake system).
|
|
|
|