Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
- Settings and routine maintenance of the car
General information
General information about settings and adjustments
Schedule of routine maintenance
Check of levels of liquids, control of leaks
Check of a condition of tires and pressure of their rating
Replacement of impellent oil and oil filter
Check of effort of a tightening of fixture of elements of a suspension bracket
Adjustment of headlights
Check of brake system
Replacement of brake liquid, pumping of brake system
Check of a condition of the battery and care of it
Check of a condition of components of a suspension bracket and steering
Check of a condition of protective covers of CV JOINTS of power shafts
Check of a condition of system of production of the fulfilled gases
Check of a condition and replacement of hoses and tubes in an impellent compartment, localization of leaks
Check of a condition and tension of a belt of a drive of auxiliary units
Check and replacement of the salonny filter of a heater and To/in
Service of locks and loops
Check of elements of systems of safety
Replacement of a filtering element of an air purifier
Check and replacement of spark plugs and ignition module
Replacement of the fuel filter
AT liquid replacement
Condition check, adjustment and replacement of brushes of screen wipers
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
AT liquid replacement
|
|
- Tire out the car on the lift, establish the AT selector lever in the situation "P" and cock the parking brake.
|
|
- Substitute under a drain stopper of AT capacity for collecting liquid. Turn out a stopper and lower ATF.
|
|
|
At ATF replacement previously it is necessary to warm up it therefore be attentive and do not burn a hand following liquid. |
- Tighten a stopper with a new sealing ring.
- Disconnect from AT a final hose and закупорьте it.
- Connect to a final opening of AT the device for washing and lower the car on the earth.
- Fill in AT of 4 l of liquid according to requirements (see. Section Check of levels of liquids, control of leaks).
- Lower the hose end in a measured vessel in capacity not less than 2 l and start the engine. At the lever which was in the position "P" of the AT selector lower 2 l of old ATF then muffle the engine.
- Fill in AT of 2 l of fresh ATF. Start the engine.
- At the lever which was in the position "P" of the AT selector lower 1 l of old ATF then muffle the engine.
- To Poddomkratta the car also establish it on props.
- Remove a hose of the device of washing and connect to AT a final hose with new consolidations. Fix a hose with effort of 27 N • m.
- Lower the car on the earth.
- Cock the parking brake, squeeze out a pedal of a brake and start the engine.
- Warm up ATF to temperature the 80th hail.
- Check and if necessary modify ATF level (see. Section Check of levels of liquids, control of leaks).
|
|
|
|