Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- Power supply system and production of the fulfilled gases
General information and security measures
Sbrasyvaniye of pressure in fuel system
- Power supply system of petrol engines
Principle of functioning of a control system of fuel injection
Removal and installation of a sleeve of an air inlet and case of the air filter
Removal and installation of sensors MAF, MAP, IAT and sensor of temperature/pressure of air of pressurization
Removal and installation of a tube of forced air
Removal and installation of the case of a throttle
Removal and installation of the control valve of forced air
Removal and installation of the perepuskny valve of a turbokompressor
Removal and turbokompressor installation
Removal and installation of an interkuler
Removal and installation of a pedal of gas, adjustment of a cable of a drive of a butterfly valve
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of assembly of the fuel pump and sensor of a stock of fuel
Removal and installation of the fuel distributive highway and injectors
Removal and installation of a regulator of pressure of fuel
+ Power supply system of the diesel V6 engine
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assembly of the fuel pump and sensor of a stock of fuel
|
|
- Execute the actions described in the item from 1 on 4 Section Removal and installation of a fuel tank.
|
|
- By means of the special adaptation turn out a carving ring.
|
- Raise the fuel pump so that its top part towered approximately on 5 cm over a fuel tank then turn the pump on an hour arrow on a corner approximately on the 80th hail. also remove the pump from a tank.
|
|
Prepare for an effluence of a small amount of fuel. |
- Check compliance of parameters of the fuel pump and the sensor of a stock of fuel to requirements of Specifications. The float of the sensor of a stock of fuel should be at distance of 0-3 mm from the bottom plane of the fuel pump.
- If necessary carry out assembly repair according to an illustration.
|
1 — the Pump
2 — Ezhektor
3 — the Filter
4 — the Tank
5 — the Submitting line of the pump
6 — the Returnable line
7 — a pump Cover
8 — the Sealing ring
9 — the Spring element
10 — the Carving ring
11 — the Filter of a radio noise |
- Clear interfaced surfaces and establish in a groove of a fuel tank a new sealing ring.
- Further installation is made upside-down. If necessary replace sealing rings of connections of fuel hoses with the pump.
|
|
|
|