Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- Power supply system and production of the fulfilled gases
General information and security measures
Sbrasyvaniye of pressure in fuel system
- Power supply system of petrol engines
Principle of functioning of a control system of fuel injection
Removal and installation of a sleeve of an air inlet and case of the air filter
Removal and installation of sensors MAF, MAP, IAT and sensor of temperature/pressure of air of pressurization
Removal and installation of a tube of forced air
Removal and installation of the case of a throttle
Removal and installation of the control valve of forced air
Removal and installation of the perepuskny valve of a turbokompressor
Removal and turbokompressor installation
Removal and installation of an interkuler
Removal and installation of a pedal of gas, adjustment of a cable of a drive of a butterfly valve
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of assembly of the fuel pump and sensor of a stock of fuel
Removal and installation of the fuel distributive highway and injectors
Removal and installation of a regulator of pressure of fuel
+ Power supply system of the diesel V6 engine
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of sensors MAF, MAP, IAT and sensor of temperature/pressure of air of pressurization
MAF sensor
|
|
|
|
- Separate the socket of the MAF sensor and weaken collars of its fastening.
|
- Remove the MAF sensor, if necessary replace it.
- Installation is made upside-down.
|
|
The arrow put on the case of the sensor, should indicate in the direction of an air stream. |
|
|
MAP sensor
|
|
|
|
- Remove the top cover of the engine, separate the socket and remove the sensor.
|
|
|
Removal of the MAP sensor of V6 engines. |
- At installation grease a sensor carving with vaseline. On V6 engines check a condition of sealing rings of the sensor and if necessary replace them.
|
|
IAT sensor
|
|
The IAT sensor is used only on 4-cylinder engines. |
|
|
|
|
- Remove a rubber cover of the socket, separate it and remove the IAT sensor.
|
- Check a condition of a sealing washer and if necessary replace it.
- At installation grease a sensor carving with vaseline.
|
|
Sensor of temperature/pressure of air of pressurization
|
|
On 4-cylinder engines the sensor of absolute pressure of air of pressurization, and on V6 engines – the combined sensor of temperature/pressure of air of pressurization is used. |
|
|
|
|
- Separate the socket and remove the sensor.
|
|
|
Removal of the sensor of temperature/pressure of air of pressurization. |
- At installation grease a sensor carving with vaseline. On V6 engines check a condition of sealing rings of the sensor and if necessary replace them.
|
|
|
|