Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
- Engine
General information and preparatory operations
Check of kompressionny pressure
Engine check by means of the vacuum gage
- Repair of 4-cylinder petrol engines
Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
Removal and installation of a head of cylinders and natyazhitel of a driving chain
Removal and installation of camshafts and valves, assessment of klapanny gaps
Check and replacement of a driving chain
Replacement of a belt of a drive of auxiliary units
Replacement of epiploons and pulley of a cranked shaft
Replacement of the oil pump
Removal and installation of the pallet of a case
Removal and installation of an arm of the filter, thermostat and reduktsionny valve of system of greasing of the engine
Check of pressure of impellent oil
Removal and installation of the power unit
Removal and installation of a cover of a drive of GRM
Check and replacement of a chain of a drive of balancing shaft and their asterisks
+ Repair of 6-cylinder petrol engines
+ Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the pallet of a case
Removal of forward section of an exhaust pipe
|
|
- Remove a decorative cover of the engine, take щуп level of impellent oil and stop up its directing with rags.
- Disconnect electroconducting from a lambda probes, disconnect a perepuskny tube of a turbokompressor and remove the thermofilter over a final collector.
- Give 2 top nuts on an exhaust pipe (4 on an illustration). To Poddomkratta the car also remove the bottom protective casing of the engine. Then give the remained fixture (6) and remove forward section of an exhaust pipe.
|
|
- Remove a protective casing from transmission (7 on an illustration). Lower impellent oil and disconnect a hose сапуна a case (9 on an illustration) from the case pallet.
|
- Give bolts of fastening of the pallet of a case and remove it.
|
|
On models with the B235R engine and RKPP for access to the hidden bolts of fastening of the pallet of a case drill openings or beat out jams (depending on a year of release) in the places specified an illustrations A. The pallet acts in film by means of the lever with the pointed end (see an illustration B). |
A
|
|
The provision of openings or jams for access to the hidden bolts. |
B
|
|
Separation of the pallet of a case from the block of cylinders of the B235R engine. |
- If the pallet of a case acts in film for the purpose of replacement, rearrange a maslootrazhatelny plate and a tube on the new pallet. Thus use new sealing rings.
- Make sure of lack of dirt in the pallet. Clear of an old prokladochny material the pallet of a case and the block of cylinders. Put a hermetic pillow in thickness of 2 mm on an interfaced surface of the pallet of a case.
- Check that the bringing tube is correctly established on the place.
- Installation is made upside-down. After installation warm up the engine and make sure of absence of leaks via the case pallet. If necessary modify level of impellent oil.
|
|
|
|