Saab 9-5

since 1997 of release

Repair and car operation

Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
- Engine
   General information and preparatory operations
   Check of kompressionny pressure
   Engine check by means of the vacuum gage
   - Repair of 4-cylinder petrol engines
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a head of cylinders and natyazhitel of a driving chain
      Removal and installation of camshafts and valves, assessment of klapanny gaps
      Check and replacement of a driving chain
      Replacement of a belt of a drive of auxiliary units
      Replacement of epiploons and pulley of a cranked shaft
      Replacement of the oil pump
      Removal and installation of the pallet of a case
      Removal and installation of an arm of the filter, thermostat and reduktsionny valve of system of greasing of the engine
      Check of pressure of impellent oil
      Removal and installation of the power unit
      Removal and installation of a cover of a drive of GRM
      Check and replacement of a chain of a drive of balancing shaft and their asterisks
   + Repair of 6-cylinder petrol engines
   + Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of an arm of the filter, thermostat and reduktsionny valve of system of greasing of the engine

PERFORMANCE ORDER

To Poddomkratta the car also establish it on props. Remove the bottom casing of an impellent compartment.

For removal of an arm remove the oil filter (see. Replacement of impellent oil and the oil filter), disconnect from an arm oil hoses and a turbokompressor tube (2 on an illustration) then remove an arm (3).

Components of installation of the thermostat.

Turn out a stopper in an arm of the oil filter and take from it a spring and the thermostat.
Turn out a stopper and take from under it a spring and the reduktsionny valve.


1 — the Valve and a spring 2 — Consolidation and a stopper

Installation is made upside-down. Previously clear interfaced surfaces. Use new sealing rings. Tighten fixture with demanded effort.

After installation check tightness of understanding connections.